We write the firmware that makes your electronic device work, from reading the sensors to connectivity. We start from your board, or design the electronics as well.
An embedded system is electronics designed for a specific task inside a product: a control unit, a connected sensor, a battery charger. The firmware is the program, loaded into the microcontroller, that decides how the product reads signals, reacts and communicates.
In short: you start from your board or from an idea; we write, test and deliver the firmware on real hardware and, if needed, design the electronics too.
The device's behaviour, written in C / C++ to your project's specifications.
Reading the sensors and driving the actuators your application requires.
Wi-Fi, Bluetooth Low Energy, LoRa, RFID and NFC, chosen according to where and how the product works.
We prepare the device to receive new firmware versions after delivery.
The right platform depends on what the product has to do. If you have not chosen one yet, we assess it together.
Prepare a block diagram or a clear description of what the device has to do, then we set up a call.
We write the firmware and test it on the real hardware, not just on a computer.
We deliver the firmware running on the board and remain available for updates.
Need the hardware too? See Electronic design.
It is an electronic system designed to perform a specific task inside a product, such as a control unit, a connected sensor or a battery charger. The firmware is the program that governs how it works.
We develop firmware on STM32, ESP32, nRF52 and Arduino. If you have not chosen a platform yet, we help you find the right one for the project.
If the hardware already exists, yes: we need a physical board for development, together with the datasheets of the sensors and actuators and, usually, the PCB schematic.
Yes. If the hardware does not exist yet, we start from the number of sensors and actuators and a block diagram of the features, and design the electronics as well.
Yes, if the device is prepared for it. Field updates must be planned at the design stage, because they depend on the hardware and the connectivity available.
It depends on the complexity of the project. After a call in which you tell us what the device has to do, we propose timing and costs.
Once your ideas are clear, write to us or call us to set up a call about your project.
STM32 firmware for the NXP PN7150 NFC controller: tags, contactless cards and smartphones.
Read the projectControl of complex heating plants: heat pumps, boilers and solar thermal.
Read the projectNetworked Li-ion chargers on ESP32-C3 that take turns over ESP-NOW.
Read the projectTell us what it has to do: we set up a call and propose timing and costs.